Ready To Cut CNC Art

Animal Bear Mascot Fridge Magnet

SignTorch

Artist
for cnc router v-carve plus outer profile cut - see below for finishing tips
bear_mascot4431.jpg
 

Attachments

You must be signed in to view attachments...
  • bear_mascot4431.dxf
    577.1 KB
use more than one magnet - some refrigerators have weak magnetic attraction

space magnets vertically - some refrigerators are curved causing horizontal spaced magnets to slip

I usually also put a slot for hanging

IMG_20220414_162337689.jpg
 
paint methods in order from easiest to hardest

1) photo shows laminate flooring - easy - just cut then paint with acrylic and wipe it off of the uncut surface - disadvantage is laminate flooring is abrasive and hard on router bits

2) pre-finish the wood - then cut - then paint and wipe as above

3) pre-finish and mask with contact paper - then cut - then paint - then peel

4) mask - shallow v-carve outline only - peel and paint inside - peel remaining outside mask

5) v-carve - paint - sand - difficult to keep paint inside lines

IMG_20220414_162321905.jpg
 
Back
Top Bottom