New to readytocut

Discussion in 'Forum Issues' started by Charlieboy, 3/20/14.

  1. Charlieboy

    Charlieboy registered

    I was a huge fan of plasmaspider up until the issue of banning signtorch, I have used signtorches design and have always appreciated the help and guidance that has been given. I am however not familiar with the zip file types compared to the dxf file types, could someone help me with this question? Please and Thank you
  2. SignTorch

    SignTorch Artist

    • Vinyl CuttingVinyl Cutting, CNC RouterCNC Router, Designer / ArtistDesigner / Artist, Hobby / PersonalHobby / Personal
    • Corel DrawCorel Draw, Adobe PhotoshopAdobe Photoshop, V-Carve ProV-Carve Pro
    Vidor, TX
    typically you save the file to your hard drive, then right click on it and hit extract-all, and follow the instructions to extract the contents

    a zip file is multiple files compressed into one

    you can also navigate into a zip file like a folder, and copy/paste or click/drag specific files out, and then open them
  3. Charlieboy

    Charlieboy registered

    I will give it a try, thank you very much for the response. Once again, your help is very much appreciated in the community of CNC cutting

Share This Page