LAPD Badge

Discussion in 'CNC Art Requests' started by 10-7Mo, 10/8/19.

  1. 10-7Mo

    10-7Mo registered

    • CNC RouterCNC Router
    • InkScapeInkScape, V-Carve ProV-Carve Pro
    Hi there,
    Anybody happen to have the LAPD badge in .dxf? I'm using vcarve pro and looking to route this onto a wooden flag. The size of the badge would be about 10" in height. Any help would be appreciated.
    4ebdd7fd841c760865432fc078a8bbd0 (1).
  2. Zepcrmc

    Zepcrmc registered

    this is a hard one to carve. ended up using a 30 degree v bit set to a max depth of .07. Make sure you set you feed rate slower than normal with all these fine lines or you will get tear out

    Attached Files:

Share This Page