Church donation.

Discussion in 'CNC Art Requests' started by sblackburn, 9/18/19.

  1. sblackburn

    sblackburn member

    Roles:
    • Plasma CuttingPlasma Cutting, Hobby / PersonalHobby / Personal
    Brands:
    • HyperThermHyperTherm
    Location:
    Chatham, Ontario
    church donation. A church has asked me to burn this out for them. I was wondering if anyone can convert it to DXF for me. I am using Vicon as a heads up. Only a few skilled of you can likely help. It's going to be cut quite large. Any help is great! Thanks in advance!
     
  2. SignTorch

    SignTorch Artist

    Roles:
    • Vinyl CuttingVinyl Cutting, CNC RouterCNC Router, Designer / ArtistDesigner / Artist, Hobby / PersonalHobby / Personal
    Brands:
    • Corel DrawCorel Draw, Adobe PhotoshopAdobe Photoshop, V-Carve ProV-Carve Pro
    Location:
    Vidor, TX

    Attached Files:

    sblackburn likes this.
  3. SignTorch

    SignTorch Artist

    Roles:
    • Vinyl CuttingVinyl Cutting, CNC RouterCNC Router, Designer / ArtistDesigner / Artist, Hobby / PersonalHobby / Personal
    Brands:
    • Corel DrawCorel Draw, Adobe PhotoshopAdobe Photoshop, V-Carve ProV-Carve Pro
    Location:
    Vidor, TX
  4. sblackburn

    sblackburn member

    Roles:
    • Plasma CuttingPlasma Cutting, Hobby / PersonalHobby / Personal
    Brands:
    • HyperThermHyperTherm
    Location:
    Chatham, Ontario
    All of these turned out amazing! Due to the church renovation they were unable to use this, this year. I'll be cutting it next year for sure! Thank you so much again!
     

Share This Page