Tree with birds

Discussion in 'CNC Art Requests' started by MrAliG, 5/27/19.

  1. MrAliG

    MrAliG registered


    We have been looking for a design for a new driveway gate for months.

    Eventually I found this design and asked the company if I could buy it but they have not responded to messages.

    I suspect it is a standard design available somewhere, but cannot find it, I found a very similar one but it was shorter and the gates are 2.2m tall.

    There are two gates, one requires a panel 5.42mx2.21m and the other 0.92x2.29m. The panels will be laser cut from steel.

    Any help on either where I might find this or a similar design would be much appreciated.

    Thanks for any help


Share This Page