Ready To Cut CNC Art

AChristina

sblackburn

member
A wood worker has asked me to make this out of steel for a insert on a live edge, epoxy table. This one here I was wondering if anyone could transform into DXF. I do use Vicon to those of you that know your compatible software. Any help would be great and will not go unappreciated!!
AChristina.jpg
 
WOWW!!!!! This is so perfect and cuts great as always!!! So much appreciation from my friend that's going to use it! I'll make sure to show you a follow up picture! Gotta run for now, headed to the donation spot! Thanks again Gary! Your the best at this!
 
Back
Top Bottom